Accessories; Operating Modes; Spin On Mode; Trigger - Honsel Rivdom eVNG 2 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 53
No .
Term
5
Blind end
Fig. e
Blind rivet
nut
Fig. f
Blind rivet
bolt
-
Spindling
2 .8

ACCESSORIES

WARNING
Unauthorised accessories
Serious injuries or material damage
Use only OEM accessories
from HONSEL.
Read and observe the
information in the operating
manual before operating the
machine.
We have the right accessories for
every application. Visit our website
or contact HONSEL Service, we
will be happy to advise you.
Some accessories can be
purchased in our shop
www.niet24.de.
36 | English
Description
The bulge of the
fastener produced by
the deformation during
the setting process that
seals the joint on one
side
Fastener with internal
thread that is set on one
side
Fastener with external
thread that is set on one
side
The process during
which the fastener
is screwed into the
threaded sleeve or onto
the threaded mandrel by
the setting tool
Accessories
Threaded mandrel
Blind rivet nut
Threaded sleeve
Blind rivet bolt
Nosepiece
Legend
 Included in scope of delivery
O Optional accessories
The same nosepiece is used for
both blind rivet nuts and blind rivet
bolts.
2 .9

OPERATING MODES

2 .9 .1 Spin on mode

There are 2 setting options for screwing on the
fastener:

Trigger

Threaded mandrel / threaded sleeve

2 .9 .1 .1 Trigger
The fastener is automatically screwed on when the
trigger is pressed.
2 .9 .1 .2 Threaded mandrel / threaded
sleeve
Screwing on of the fastener starts automatically
when the fastener is pressed against the threaded
mandrel or threaded sleeve.

2 .9 .2 Setting mode

The fastener can be set in either force-controlled or
stroke-controlled mode.

2 .9 .2 .1 Force

The fastener is set under force control. The setting
tool sets the fastener with a preset force.

2 .9 .2 .2 Stroke

The fastener is set under stroke control. The
setting tool sets the fastener until a preset stroke is
reached.

2 .9 .3 Emergency mode

Emergency mode can be started if the fastener has
tilted with the threaded mandrel / threaded sleeve
during the setting process and can no longer be
unscrewed. The fastener can then be separated
O      O
O O O O
O      O

Publicidad

Tabla de contenido
loading

Tabla de contenido