Install Threaded Mandrel / Threaded Sleeve And Nosepiece; Set Up The Setting Tool For The Setting Process; Set Up The Setting Tool Again - Honsel Rivdom eVNG 2 Instrucciones De Uso

8. Select menu item Tool Lock using the arrow
keys.
9. Confirm the selection with the OK key.
The text Press OK for lock state Unlocked
»
appears on the screen.
10. Press the OK key to unlock the tool.
11. If necessary, select Back on the screen until
the Rivdom eVNG Main menu is displayed.
12. Navigate to Exit using the arrow keys.
13. Confirm the selection with the OK key.
The setting tool is unlocked.
»
The unlocked starting mask / working
»
mask appears on the screen.
3 .4 INSTALL THREADED MANDREL /
THREADED SLEEVE AND
NOSEPIECE
Installation requires no tools.
A threaded mandrel or threaded
sleeve and a nosepiece with the
same diameter must always be
installed.
Installation is described in the
enclosed quick guide.
See figure b, Installation of threaded mandrel /
threaded sleeve
No . Designation
1 Union nut
2 Nosepiece
3 Union nut O-ring
4 Front sleeve with O-ring
5 Clamping sleeve
6 Threaded mandrel / threaded sleeve
7 Spindle adapter
8 Safety slide
9 Spring
1. Press the battery release button and remove
the battery from the setting tool.
2. If a nosepiece is already installed on the
setting tool, unscrew it by hand in anti-
clockwise direction and remove.
3. Unscrew the union nut by hand in anti-
clockwise direction and remove.
The front sleeve is released.
»
40 | English
4. Remove the front sleeve with O-ring.
5. Press the safety slide against the spring and
hold.
6. Unscrew the clamping sleeve by hand in
anti-clockwise direction and remove.
7. Release the safety slide again.
8. If a threaded mandrel or threaded sleeve is
already installed in the setting tool, remove the
threaded mandrel / threaded sleeve.
9. Push the desired threaded mandrel or threaded
sleeve into the spindle adapter.
10. Push the clamping sleeve onto the threaded
mandrel or threaded sleeve.
11. Screw the clamping sleeve with threaded
mandrel or threaded sleeve onto the spindle
adapter by hand in clockwise direction until the
clamping sleeve engages in the safety slide.
12. Push the front sleeve with O-ring onto the
clamping sleeve and threaded mandrel /
threaded sleeve.
13. Push on the union nut and tighten by hand in
clockwise direction.
The nosepiece used must have
the same diameter as the threaded
mandrel or threaded sleeve used.
14. Screw the matching nosepiece onto the front
sleeve by hand in clockwise direction.
15. Insert the battery into the setting tool again.
The setting tool is ready for operation.
»
3 .5 SET UP THE SETTING TOOL FOR
THE SETTING PROCESS

3 .5 .1 Set up the setting tool again

The setup is also described in the
enclosed quick guide.
Precondition:
• The battery is fully charged, see chapter 3.2.
• The desired threaded mandrel or threaded
sleeve and the desired nosepiece are fitted,
see chapter 3.4.
• There is a drill hole for the fastener in the part.
• The setting tool is unlocked, see chapter 3.3.
1. Insert the battery into the setting tool.
2. Press the trigger briefly.
The unlocked starting mask / working
»
mask appears on the screen.
3. Hold the OK key pressed for 2 seconds.
The Rivdom eVNG Main menu appears on
»
the screen.
4. Select menu item Setup using the arrow keys,
5. Confirm the selection with the OK key.