Operation - Ego Power+ ZT5200L Manual Del Operador

OPERATION

WARNING: Do not allow familiarity with this product to make you careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this product. The
use of attachments or accessories not recommended can result in serious personal injury.
APPLICATION
You may use this product for purpose listed below:
◾
Mowing your lawn.
MOWER ADJUSTMENT
CUTTING-DECK HEIGHT ADJUSTMENT (Fig. 16)
NOTICE: EGO electric zero turn mower's deck is set in the highest
cutting height when it is shipped. Before using the mower, the
operator should adjust the deck height to the cutting position best
suited for the lawn.
NOTICE: To prevent scalping the lawn when encountering high
spots, the three anti-scalp wheels can be adjusted when the mower
is at the desired cutting height. Depending on your desired cutting
height, you may need to change the position of the anti-scalp
wheels. please refer to "ADJUSTING THE ANTI-SCALP WHEELS"
section in this manual.
1. Make sure that the batteries have been removed from the
mower before making any adjustments.
2. To lower the cutting height, grasp the deck-height adjustment
lever and move it inwards to disengage it from the detent. Move it downward and engage it into the detent when it
arrives at the desired cutting height.
3. To raise the cutting height, grasp the deck-height adjustment lever and move it inwards to disengage it from the
detent. Move it upward and engage it into the detent when it arrives at the desired cutting height.
NOTICE: Prior to mowing, the deck should be adjusted to sufficient height to avoid stumps, rocks or other obstacles that
can damage the mower deck.
DANGER : Never attempt to make any adjustments to the mower deck while the mower is driving or the cutting
blades are turned on. Mower blades cannot be seen and are located very close to the deck housing. Fingers and toes can
be cut off instantly.
WARNING: Hold the deck-height adjustment lever firmly when setting the deck height and only release when it is
securely engaged in the desired detent. Quickly letting go of the lever may create a pinching or pulling hazard to the
operator's hand.
34
56-VOLT LITHIUM-ION ELECTRIC ZERO TURN MOWER — ZT5200L/ZT5200L-FC
16
b
a