Before Using The Bottle; Assembling The Bottle - Philips AVENT SCF393 Manual Del Usuario

English
18
- Never attach to cords, ribbons, laces or loose parts of clothing. The child can be strangled.
- Never use feeding teats as a soother.
- Always use this product with adult supervision.
- Keep the bottle cap away from children to avoid suffocation.
- Do not allow children to play with small parts or walk/run while using bottles.
- Inspect all parts before use and pull the feeding teat in all directions. Throw away any part at the
first signs of damage or weakness.
- Always discard any breast milk that is left over at the end of a feed.
Caution: To avoid damage to the bottle
- Do not place in a heated oven, plastic can melt.
- Plastic material properties may be affected by disinfection and high temperatures. This can affect
the fit of the bottle cap.
- Do not leave a feeding teat in direct sunlight or heat, or leave in disinfectant for longer than
recommended because this may damage the product.

Before using the bottle

- Inspect the bottle and feeding teat before each use and pull the feeding teat in all directions to
prevent a choking hazard. Throw away at the first signs of damage or weakness.
- Clean and disinfect the bottle before first use and after every use (see 'Cleaning and disinfecting').

Assembling the bottle

1. The teat is easier to
assemble if you move it
back-and-forth while
pulling it upwards
instead of pulling it up
in a straight line.
2. Make sure you pull
the teat through until
its lower part is aligned
with the screw ring.
3. Make sure you place
the cap vertically onto
the bottle so that the
teat sits upright.
4. Screw the screw ring
with teat and cap on
the bottle.