Devolo MAGIC 2 Manual página 95

27 Initial use
Please note that your computer or other de-
vice must have a network card or network
adapter with a network interface.
To set up a devolo network, you need at
least two devolo adapters.
3.3 Connecting the
devolo Magic 2 WiFi 6
CAUTION! Damage to the device caused
by ambient conditions
Only use device indoors in dry conditions
In the following sections we describe how to
connect the devolo Magic 2 WiFi 6and integrate it
into a network. We clarify the exact procedures ba-
sed on potential network scenarios.
For the permitted voltage range for opera-
ting the device and the power consumption,
refer to the type plate on the rear of the de-
vice. For additional technical information on
our products, refer to the product area at
www.devolo.global.
devolo Magic 2 WiFi 6
3.3.1 Starter Kit – Automatic set-up for a
new devolo Magic PLC network
Connect one devolo Magic 2 LAN
1
Internet access device's network connection
(e.g. your Internet router).
CAUTION! Tripping hazard
Lay the network cable in a barrier-free
manner and ensure that the electrical
socket and the connected network de-
vices are easily accessible
Plug both devolo Magic adapters into available
2
power sockets within 3 minutes. As soon as the
LEDs on both adapters flash white at regular
intervals of 0.5 sec., they are ready to operate
and automatically start the process of establis-
hing an encrypted connection to each other
(see Chapter 2.4.1 Reading the PLC indicator
light).
If the LEDs on both devolo Magic adapters
light up in white, then your devolo Magic
network has been set up according to your
individual specifications and is protected
from unauthorised access.
1-1
to your