Devolo MAGIC 2 Manual página 98

3.5 Removing the devolo Magic
adapter from a PLC network
To remove a devolo Magic adapter from your net-
work and successfully restore its entire configurati-
on to the factory default settings, press the reset
button longer than 10 seconds. Wait until the LED
flashes white and then disconnect the adapter
from the mains supply.
Keep in mind that all settings that have al-
ready been made will be lost!
To integrate the mains supply into another net-
work, proceed as described in Chapter 3.3.2 Addi-
tion – Expanding an existing PLC network by
adding another devolo Magic 2 WiFi 6.
Initial use 30
devolo Magic 2 WiFi 6