First Steps; Assembly - BRAND Dispensette S Instrucciones De Manejo

First Steps

Is everything in the package?
Confirm that your package includes:
Bottle-top dispenser Dispensette
recirculation valve, telescoping filling tube, recirculation tube (included only in recirculation valve models),
mounting tool, bottle adapters (listed below), a performance certificate and this operating manual.
Nominal volume, ml
1, 2, 5, 10
25, 50, 100

Assembly

Warning:
Wear protective clothing, eye protection and gloves! Follow all safety
instructions and observe limitations of use and operating limitations
(page 34-36).
1.
Mounting the
filling tube/ recir-
culation tube
2.
Mounting the
instrument on a
bottle and align-
ment
40
S or Dispensette
®
Adapters for
bottle thread
GL 24-25, GL 28/S 28, GL 32-33, GL 38, S 40 125-240
GL 32-33, GL 38, S 40
Adjust the length of the telescoping filling
tube to the bottle height and attach it.
Center and attach the filling tube care-
fully to avoid damaging the nozzle. If a
discharge tube with a recirculation valve
is used, the optional recirculation tube
must also be installed. Insert it with the
opening pointing outward (Fig. 1).
Screw the instrument (GL 45 threads)
onto the reagent bottle, and then align
the discharge tube with the bottle label.
This is done by rotating the valve block
with the discharge tube (Fig. 2).
To avoid tipping over, use a bottle stand
for small bottles.
S Organic, discharge tube or discharge tube with
®
Filling tube
Length, mm
170-330
1
2