Removing A Devolo Wifi 5 Repeater 1200 From The Network - Devolo WiFi5 Repeater 1200 Manual

If the WPS function is activated, the WPA3
encryption mechanism is not usable for
technical reasons.
For more information about selecting an en-
cryption mechanism, refer to Chapter 4.5
Wi-Fi settings.
As soon as the status bar has been run
through and the dot LED (see Chapter 2.1.2
Reading the Wi-Fi indicator light) of the
Wi-Fi symbol lights up green on the device,
the devolo WiFi 5 Repeater 1200 has been
successfully defined as an Access Point.
For information about other possible device
settings, refer to Chapter 4 Network
configuration.
3.3 Removing a
devolo WiFi 5 Repeater 1200
from the network
To remove a devolo WiFi 5 Repeater 1200 from
your network and successfully restore factory de-
faults for its entire configuration, press the reset
button for 5 seconds using a paper clip or a similar
object. Wait for the dot LED of the Wi-Fi symbol to
flash orange and then disconnect the adapter from
the power grid.
Keep in mind that all settings that have already
been made will be lost!
Then, if you want to integrate this adapter into a
different network, proceed as described in Chapter
3.2 Installing devolo WiFi 5 Repeater 1200.
devolo WiFi 5 Repeater 1200
Initial use 24