Settings - Devolo WiFi5 Repeater 1200 Manual

immediately. If no stations are connected, the
device automatically selects a channel every 15
minutes.
It is worth noting that connected devices also have
to support the increased frequency band of 5 GHz.
From channel 52 onward you go into the radar
range. When accessing the device for the first time,
a radar detection phase (DFS) starts automatically,
during which
devolo WiFi 5 Repeater 1200 cannot be accessed
via Wi-Fi. This may take up to 10 minutes.
You can manually select a 2.4 GHz and a 5 GHz
channel for each device. If you are not sure which
wireless channels are used by nearby devices,
select the Automatic option.
Confirm your settings with Apply.
The devolo WiFi 5 Repeater 1200 supports both
the parallel operation of the Wi-Fi frequency bands
and their separate use.
Keep in mind that after saving this setting, you
will be disconnected from any existing wireless
connection to the devolo WiFi 5 Repeater 1200.
In this case, configure the device over Ethernet.

4.5.1 Settings

The Settings section offers functions and configu-
ration options for the security of the device.
time the
Device LED
The LED status display can be switched on or off.
An error status is indicated by corresponding flash-
ing behaviour regardless of this setting.
Save/Restore settings
To save the active configuration as a file on your
computer, click the Save button in the Save
Settings area. The system starts downloading the
current device configuration.
In the Restore Settings section, an existing
configuration
devolo WiFi 5 Repeater 1200 and activated there.
Select a suitable file clicking the Browse... button
and start the operation by clicking the Upload
button.
Network configuration 30
file can be sent to
devolo WiFi 5 Repeater 1200
the