Start Using Your Cooker Hood; Troubleshooting - Candy CDG6CBG Manual De Instrucciones

Start Using Your Cooker Hood

Touch control
1. Press the "Power" button, the button control the "on" & "off " of the hood.
2. Press the button "Speed" time after time, the motor runs as low / mid / high / low /
mid..., the speed runs circularly; and the LED display will indicate as 1-2-3-1-2...
circularly.
3. Press "Lamp" button, the light is on, press this button again, the light is off. Please
note the Lamp is not under control of the on/off button.
4. When the hood is working, if press the "Timer" button, the hood will go into the
status of acquiescent working (acquiescent time is 9mins), and then, LED display
will be shown 9.8.7.6 ...decreasing by 1,when time is up, the hood will be off
automatically and the lamp will extinguish. If pressing "Timer" button, the hood will
go in or go out "Timer" function.

TROUBLESHOOTING

Fault
Light on, but motor
does not work
Light does not
work, motor does
not work
Oil leakage
Lights not working
Insufficient suction
The Cooker hood
inclines
Possible Cause
Fan switch turned off
Fan switch failed
Motor failed
House fuses blown
Mains power cable is loose or
disconnected
One way valve and the outlet
are not tightly sealed
Leakage from the connection of
chimney and cover
Broken or faulty bulbs
The distance between the
cooker hood and the gas top is
too far
The fixing screw is not tight
enough
Select a fan switch position.
Contact service center.
Contact service center.
Reset/Replace fuses.
Refit mains power cable to
power outlet.
Switch power outlet on.
Take down the one way valve
and seal with sealant.
Take chimney down and seal.
Replace blubs as per this
instruction.
Refit the cooker hood to the
correct distance.
Tighten the hanging screw and
make it horizontal.
10
Solution