Technical Data; Notes On Safety; Symbols - Deltafox DG-CCS 1825 Traducción Del Manual De Instrucciones Original

24 Lug
25 Chain tensioner pin holder
26 Chain tensioner pin
27 Oil level control
28 Oil passages

Technical Data

Cordless chainsaw ........... DG-CCS 1825
................... ....................... DG-CCS 1825 Set
Rated input voltage .........................18 V
Idle time ...................................20-28 min
Idling speed ............................. 3000 min
Chain speed v ............................. 5.6 m/s
0
Weight
(without battery and charger) ...... 3.2 kg
Oiltank ........................................... 220 ml
Chain bar .........................................Trilink
Chain ...........................Trilink CL15040PB
Chain pitch....................... 3/8" (9,5 mm)
Chain width ............................... 1.3 mm
Teeth of the sprocket chain wheel ....... 6
Sawing length ................. approx. 250 mm
Acoustic pressure level
(L ) .................. 86.2 dB(A); K
pA
Sound power level (L
measured ......96.1 dB(A); K
guaranteed ..............................99 dB(A)
Vibration (a ) .......... 2.47 m/s
h
Noise and vibration values were deter-
mined according to the standards and
stipulations mentioned in the declaration
of conformity.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to
compare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
= 3.0 dB
pA
)
WA
= 2.67 dB
WA
, K=1.5 m/s
2
Warning: The vibration emission
value may differ during actual use of
the power tool from the stated value
depending on the manner in which
the power tool is used.
Try to keep the exposure to vibra-
tions as low as possible. Examples of
measures to reduce vibration expo-
sure are the wearing of gloves when
using the tool and limiting the work-
ing hours. All parts of the operating
cycle are to be taken into account in
this (for example times in which the
electric tool is turned off and those in
*
which even though it is turned on, it
-1
is not running under a load).

Notes on safety

This section deals with the basic safety
regulations while working with the chainsaw.
Before working with the chainsaw,
familiarise yourself with all the con-
trols. Practise handling the saw (by
cutting logs to size on a sawhorse)
and have the functionality, mode of
action, sawing techniques and per-
sonal safety equipment explained
to you by an experienced user or
an expert.
2

Symbols

Symbols used on the saw
A chainsaw is a dangerous de-
vice, which can cause serious or
even fatal injuries with incorrect or
careless use. Thus, for your own
safety and the safety of others, you
should always take note of the in-
structions on safety and, in case of
difficulties, consult a specialist for
advice.
GB
77