Operation Startup; Fitting The Blade And Saw Chain - Deltafox DG-CCS 1825 Traducción Del Manual De Instrucciones Original

GB

Operation startup

Always wear protective gloves
when working with the chainsaw
and employ only original parts.
Injury hazard!
Prior to commissioning the device, you
must:
- assemble the blade and the sawing
chain
- tension the sawing chain
- fill it with biological chain oil
- charge and insert the battery
- test the oil automatics and the operabil-
ity of the chain brake
Note that the saw can re-oil.
Please note that the saw re-oils after
use and oil may leak out if it is stored on
its side or on the head. This is a normal
process due to the necessary ventilation
opening on the upper edge of the tank and
does not constitute a reason for complaint.
As each saw is checked during production
and tested with oil, a small residue may
be in the tank despite draining, which may
slightly dirty the housing with oil in transit.
Please clean the housing with a cloth.

Fitting the blade and saw chain

Switch off the device and remove the
battery from the device.
1. Lay the saw on a flat surface.
2. Turn the fastening bolt (13) anti-
clockwise (
the sprocket chain wheel cover-
ing (15).
3. Spread the chain (5) out into a
loop with the cutting edges run-
ning clockwise .Use the graphical
84
) to remove
symbol on the blade or below the
chain sprocket (22) as a guide to
align the saw chain (5).
Direction of travel of
saw chain
4. Slide the saw chain (5) into the
bar guide groove. To mount the
guide bar (4), raise it to an angle
of approx. 45 degrees. This will
make it easier to replace the saw
chain (5) onto the sprocket (22).
5. Place the chain bar (4) and saw
chain (5) on the bar bolts (23).
When the lug (24) to the right of
the coach screw (23) sits in the
slotted recess on the blade, the
blade is placed correctly. It is
normal that the saw chain (5) is
slack.
6. Place the sprocket cover (15) into
position. The chain tensioner pin
(26) on the inside of the sprocket
cover (15) must be guided into
the chain tension pin holder (25).
7. Slightly tighten the mounting
screw (13) of the sprocket cover
( ).
8. Pre-tension the saw chain (5) by
turning the screw for the chain
quick-tensioning system (14) in a
clockwise direction.
9. Tighten the mounting screw (13)
of the sprocket cover ( ).