Adjusting The Chain Tension; Starting Up A New Saw Chain; Maintaining The Chain Bar - Deltafox DG-CCS 1825 Traducción Del Manual De Instrucciones Original

GB
5. The chain is worn and must be
replaced by a new saw chain if
only approx. 4 mm of the cutting
teeth is remaining.
6. After the sharpening, all cutting
elements must now be equal in
length and width.
7. After every third sharpening, the
sharpness depth (depth limita-
tion) must be checked and the
height filed with the aid of a flat
file. The depth limitation should be
set back about 0.65 mm from the
cutting tooth. After the setting
back of depth limitation, round it
off a little at the front.

Adjusting the chain tension

The adjustment of the chain tension is de-
scribed in the chapter: Starting operation,
tensioning chainsaw.
• Switch off the device and remove the
battery from the device
• Check the chain tension regularly and
re-adjust this as often as possible.When
the saw chain is tensioned with 9 N
(approx. 1 kg), the gap between the
saw chain and the guide rail may not
be more than 2 mm.

Starting up a new saw chain

In the case of a new chain, the tensioning
force decreases after some time. Therefore
you must re-tension the chain after the first
5 cuts and at longer intervals after this.
Never attach a new chain to a
worn drive pinion or place onto
a damaged or worn chain bar.
The chain could spring back or
break, potentially leading to seri-
ous injury.
92

Maintaining the chain bar

Use cut-protection gloves when
handling the chain or the chain bar.
1. Switch off the saw and remove the bat-
tery from the device (
2. Remove the sprocket chain wheel cov-
ering (15), the saw chain (5) and the
chain bar (4).
3. Check the chain bar (4) for wear. Re-
move burrs and straighten the guide
surfaces with a flat file.
4. Clean the oil passages (
the chain bar, in order to guarantee
a trouble-free, automatic oiling of the
saw chain during operation.
5. Mount chain bar (4), chainsaw (5) and
sprocket chain wheel covering (15) and
tighten the chainsaw.
With the oil nozzles in good condi-
tion and the oil regulator set cor-
rectly, the saw chain will spray a
little oil off after starting.
The blade (4) must be inverted every 8-10
working hours in order to guarantee even
wear.
1. Switch off the saw and remove the bat-
tery from the device (
2. Remove the sprocket chain wheel cov-
ering (15), the saw chain (5) and the
chain bar (4).
3. Turn the blade around its horizontal
axis and install the blade and chain as
described under "Fitting the blade and
saw chain".
When doing so, pay attention to the
correct rotation direction of the saw
chain!
Direction of travel of the
saw chain
19).
28), of
19).