Indicator Charge Level; Removing / Inserting The Battery; Switching On; Checking The Chain Brake - Deltafox DG-CCS 1825 Traducción Del Manual De Instrucciones Original

GB
Make sure you have a secure
stance. Before starting, ensure that
the electric chainsaw is in contact
with no objects.
Caution! Saw can oil up, see notes
on Operation startup.

Indicator charge level

Press the „Press" button on the right of
charging level indicator (
to check the status of the battery.
The number of illuminated LED lights
shows the charge level of the battery.
Removing / inserting the
battery
1. To remove the battery (19) from the
appliance, press the release button
( 19a) on the battery and pull out
the battery.
2. To insert the battery (19), place it on the
guide track (17) and push it back into
the appliance. It will audibly snap in.

Switching on

1. Check before the start, whether suffi-
cient chain oil is in the tank and, if nec-
essary, refill with chain oil (see Chapter
"Operation startup").
- the charge status of the battery
(see ).
2. Release the chain brake, where you
shift the brake arm (3) back against
the front grip (8).
3. Hold the chainsaw firmly with both
hands, with the right hand on the rear
grip (1) and the left hand on the front
handle (8). Thumb and finger must
close securely over the handles.
4. For switching on, activate the switch-
on block (10) with the right thumb and
86
5. The power saw switches off when you

Checking the chain brake

19b), in order
then press the On/Off switch (11), the
chainsaw runs with highest speed.
Release the switch-on block again
release the On/Off switch (11) again.
Switching for continuous running is not
possible.
The motor cannot be turned on if the
chain brake has engaged. Do not
employ the chain brake in order to
start the chainsaw or to switch it off.
1. Place the chainsaw onto a solid,
flat surface. It must not contact
any objects.
2. Release the chain brake, where
you shift the brake arm (3) back
against the front grip (8).
3. Hold the chainsaw firmly with
both hands, with the right hand
on the rear handle (
left hand on the front handle
( 8). Thumb and finger must
close securely over the handles.
4. Turn on the chainsaw.
5. Activate the chain braking le-
ver (3), with running motor, with
the left hand. To do so, push the
chain braking lever/front hand
protection (3) away from the front
handle (8).
Chain should stop abruptly.
6. Once the chain brake is work-
ing properly, release the on/off
switch (10) and the chain brake.
If the chain brake does not func-
tion correctly, you must not use
the chainsaw. A slack saw chain
leads to danger of injury. Return
the chainsaw to our Service-
Center for repair.
1) and the