Operation - Dimplex CEL50 Manual Del Propietário

Operation

Figure 18
C
 
WARNING: This electric
firebox must be properly
installed before it is used.
The manual controls for the
electric fireplace are located on
the right side of the unit and inside
the air intake slot (Figure 18).
A. On/Off Switch
The On/Off Switch supplies power
to all fireplace functions. When
the switch is in the " I " position,
the unit is on. When in the " O "
position, the fireplace is off.
B. 3-Position Switch
The 3-Position Switch changes the
mode the fireplace operates in and
has three (3) positions: " MANUAL
"; " OFF "; and " REMOTE ".
When in " REMOTE " mode, the
fireplace's three levels of operation
18
B A
are controlled by the ON and OFF
buttons of the remote control.
In " OFF " mode, power to all
functions is cut off.
In " MANUAL " mode, the
fireplace's three levels of operation
are controlled by the Manual
Control Buttons.
C. Manual Control Buttons
The Manual Control Buttons
operate the fireplace levels
sequentially (from off): flames
only; to flames and low heat; to
flames and high heat.
The level is increased every time
the " I " button is pressed, and the
fireplace can be turned off at any
point by pressing the " O " button.
!
NOTE: The heater may emit
a slight, harmless odor when
first used. This odor is a normal
condition caused by initial heating
of internal heater parts and will not
occur again.
Resetting the Temperature
Cutoff Switch
Should the heater overheat, an
automatic cut out will turn the
fireplace off and it will not come
back on without being reset. It can
be reset by switching the On/Off
www.dimplex.com