Surface Installation - Dimplex CEL50 Manual Del Propietário

Fireplace Installation
14. Reposition the electrical box
cover over the wires and
connectors and attach to
fireplace chassis using the
screw removed in step 3.
15. Carefully reinsert partially
reflective glass into fireplace
and anchor in place using
glass brackets and screws
removed in step 1.
16. Refer to Front Glass
Installation section, page
16 for final installation
procedures.
For Bathroom Use
If this unit is installed in a
bathroom it must be protected
by a GFCI receptacle or circuit.
If receptacle is used it must be
readily accessible.
To prevent electrical shock this
unit is an electrical appliance
that is not watertight and must
be installed as to prevent water
from entering unit. This must be
installed away from showers,
tubs, etc. Never locate fireplace
where it may fall into a bathtub or
other water container.

Surface Installation

CAUTION: Two people may
be required for various steps
of this procedure.
12
1. Choose a location which has
a minimum of two wall studs
available for mounting.
2. Choose your method of
supplying power to the unit:
• Plug in to an existing outlet or
install an outlet nearby.
• Hard wire the fireplace. Follow
the hard wiring instructions on
page 9.
WARNING: Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of fire,
electric shock or injury to persons,
always use a licensed electrician.
Ensure that the On/Off Switch
is set to the Off position (refer to
Operation section) and that the
circuit on which the fireplace is to
be installed has the power cut off at
the service panel until installation is
complete.
3. Remove the partially reflective
glass from the fireplace:
• Lay fireplace on its back.
• Remove two Phillips screws
from each of the two glass
brackets (Figure 2, page 9).
• Remove glass brackets.
• With one hand keeping
pressure on the partially
reflective glass, tilt the
fireplace upright and slightly
www.dimplex.com