Airwell CDMX-035N-09M25 / YDAX-035H-09M25 Manual De Instrucciones página 45

NOTE: If the height of the indoor unit needs
to be adjusted, you can do so through the
openings at the panel' s four corners. Make
sure that the internal wiring and drainpipe
are not a ected by this adjustment.
Water condensation
CAUTION
Failure to tighten screws can cause water
leakage.
Gap not allowed
CAUTION
If the unit is not hung correctly and a gap exists,
the unit' s height must be adjusted to ensure
proper function. The unit' s height can be
adjusted by loosening the upper nut, and
adjusting the lower nut.
Hang the intake grille on the panel, and then
connect the lead connectors of the louver motor
and the control box on the panel to the
corresponding connectors of the main body.
Install cover rope
Re-installed into the style grid.
Reinstall the installation cover.
Fix the installation cover plate rope to the pillar of
the installation cover plate, and gently press the
installation cover plate into the panel.
1
Loosen upper nut
2 Adjust lower nut
NOTE: After installation, the butt plugs of
display, swing, water pump and other wire
bodies must be placed in the electric control
box.
Panel hook
When installing the
cover, slide the four
slide fasteners into
the corresponding
slots on the panel.
Bolt
Page 44
 