Panasonic AW-E750E Instrucciones De Operación página 51

G/L Adjustment Set Display
1. Horizontal Phase Adjustment
[H Phase: –206 to +49]
Horizontal phase can be adjusted when a genlock
signal is supplied.
2. Sub Carrier Phase Coarse Adjustment
[SC Coarse: 1, 2, 3, 4]
Coarse adjustment of subcarrier phase can be made
when a genlock signal is supplied.
3. Subcarrier Phase Fine Adjustment
[SC Fine: –511 to +511]
Fine adjustment of subcarrier phase can be made
when a genlock signal is supplied.
Sharpness (DTL) Set Display
1. Detail Select Setting
[DTL Select: Normal, Super DTL]
If contour correction is not sufficient at the Normal
position when Detail Level setting is set to LOW or
HIGH, select the Super DTL position.
Note
Neither Normal nor Super DTL is valid for
contour correction if Detail Level setting is in
the OFF position.
2. Detail Level Setting [Level: OFF, LOW, HIGH]
Detail level can be adjusted when Detail Select setting
is at Normal. Super DTL level can be ad justed when it
is at Super DTL.
In case of using the RCU, the above can be adjusted
with the detail compensation selector switch (DTL).
In the case of the ROP, the ON or OFF status is
selected alternately every time the DTL button is
pressed.
The settings in the ON status are performed on the
LCD panel.
Remote control unit
- 50 (E) -
Detail compensation
selector switch