Panasonic AW-E750E Instrucciones De Operación página 66


Other Set Display
1. Gamma Correction Level Setting
[Gamma: 0.35 to 0.55]
Gamma correction level can be set.
2. Knee Compensation Level Setting
[Knee Point: 88 % to 98 %, Dynamic]
88 % to 98 %: The level of video signals subject to
knee compensation (knee point) can be set.
Dynamic: Knee compensation level is automatically
adjusted according to the scene.
3. White Clip Level Setting
[White Clip: 95 % to 110 %]
The peak level of video signals to be white-clipped
can be set.
4. Flare Correction Level Setting
[Flare R/G/B: 0 to 100]
Flare correction level can be adjusted.
K Flare correction level has already been adjusted
prior to shipment from the factory.
5. Black Stretch Setting [Black Stretch: ON, OFF]
Black stretch to correct the suppression of black
portions at low luminance can be set to ON or OFF.
6. Clean DNR Setting [Clean DNR: HIGH, LOW, OFF]
This enables the clean DNR effect to be selected.
7. 3D-DNR Setting [3D-DNR: OFF, Low, Mid, High]
This enables the 3D-DNR effect to be selected.
K When "Mid" or "High" is selected, the noise is
reduced but lag increases.
8. 2-dimensional Lowpass Filter Setting
[2D LPF: OFF, LOW, HIGH]
The 2D lowpass filter that reduces moire and cross
colour can be set.
9. CCD Read Out Mode Setting
[Field/Frame: Field, Frame 1, Frame 2]
Field: CCD storage will be by field storage.
Frame 1: Vertical resolution increases in frame
storage.
Frame 2: Vertical resolution is raised without
increasing residual images by frame storage and
electronic shutter.
10. PC Control Access Speed Setting
[Baud Rate: 1200 bps, 2400 bps, 4800 bps, 9600 bps]
This setting is to select a communication speed in
controlling the camera from the computer.
- 65 (E) -