Operation; Starting Up - Scheppach AB1900 Traducción Del Manual De Instrucciones Origina

• Check the alignment of all moving parts, broken or mounting parts, and other conditions
that could impair proper operation. Any damaged part should be repaired or replaced by
a qualified technician.
• Do not use the machine if a switch cannot be switched on and off correctly.
Caution! Before beginning the operation, check the installation site for concealed electri-
cal cables, gas and water pipes using a pipe locator.

8. Operation

• Use only proper equipment.
• Make all machine adjustments only with the machine switched off.
• Never leave the machine unattended while it is running.
• When switching off, leave the machine only after it comes to a complete standstill.
• Turn the machine off before you unplug it.
• Always unplug the mains cord. Never pull out the plug from the wall outlet by holding the
cable.
• Perform maintenance and cleaning of the device regularly.

9. Starting up

Using the chisel (fig. 2)
1. Clean chisel always before inserting it and lubricate the shaft slightly.
2. Pull out the locking bolts (8) up to the end stop, turn by 180° and release.
3. Insert chisel into the tool holder (6) and slide it up to the end stop.
4. Pull out the locking bolts (8) once again, turn by 180° and release.
5. Check lock on the tool.
Remove chisel
Pull out the locking bolts (8) up to the end stop, turn by 180° and release, and remove the
chisel.
Additional handle (fig.3)
For safety reasons, use the demolition hammer only with the additional handle!
1. The additional handle (5) provides you safe grip while using the demolition hammer.
2. The additional handle (5) can be rotated to any position.
3. Loosen the screw (9).
4. Turn the additional handle (5) to a convenient and safe working position and tighten the
screw (9) again.
www.scheppach.com
GB | 33