Sauder 109872 Manual De Instrucciones página 21

Step 17
With someone's help, carefully position the 109848 Return Kit next to the 109872 U-Shaped
å
Connector Kit as shown in the diagram.
Fasten both connector plates (from the 109848 Return) to the bottom of the MOLDINGS on the
å
Return Kit and U-Shape Connector Kit. Use eight BLACK 9/16" LARGE HEAD SCREWS (from the
109848 Return Kit) through each plate and into the pre-drilled holes in the MOLDINGS of both units.
NOTE: The Connector Plates may already be assembled to the 109848 Return Kit. If so, the
å
Connector Plates will each require only four BLACK 9/16" LARGE HEAD SCREWS.
Now, fasten the modesty panel of the 109848 to the INNER END (B) on the U-Shape Connector
å
Kit. Use three BROWN 1-1/2" FLAT HEAD SCREWS with WASHERS (from the 109848 Return Kit)
through the holes in the modesty panel and into the pre-drilled holes in the INNER END on the Desk.
IMPORTANT: The 109848 Return Kit must be attached to the 109872 U-Shape Connector Kit as
å
indicated in this step.
BLACK 9/16" LARGE HEAD SCREW
(16 used from the 109848 Return Kit for
the PLATES from the Return Kit)
www.sauder.com/services
Return Kit on the RIGHT
109872
U-Shape
Connector Kit
109843
Executive Desk
B
Fasten the modesty panel on
the 109848 along this edge of
the INNER END (B) using the
1-1/2" FLAT HEAD SCREWS and
WASHERS you saved from step 1.
WASHER BROWN 1-1/2" FLAT HEAD SCREW
(3 of each used from the 109848 Return Kit)
109872
109848
Return Kit
M o
d e s
t y P
a n e
l
Page 21