Sauder 109872 Manual De Instrucciones página 27

Step 23
Fasten the BOTTOM (H) to the OUTER END (A) and INNER END (B). Use four BLACK 1-7/8" FLAT HEAD SCREWS (X).
å
NOTE: Be sure the FEET (R) are facing up.
å
Next, fasten the support bracket (from the 109848 Return Kit) to the TOP (E2) and MODESTY PANEL (F). Use three
å
BLACK 9/16" LARGE HEAD SCREWS (from the 109848 Return Kit).
NOTE: The longer arm of the bracket should be fastened to the MODESTY PANEL. Use one pre-drilled hole in the TOP
å
and two pre-drilled holes in the MODESTY PANEL.
Now, fi nish fastening the support bracket to the TOP (E2) and MODESTY PANEL (F). There are three remaining holes in
å
the bracket. Turn three BLACK 9/16" LARGE HEAD SCREWS (from the 109848 Return Kit) through these holes and into
the TOP and MODESTY PANEL.
NOTE: There are no pre-drilled holes for these three SCREWS. Use fi rm pressure to get them started.
å
SUPPORT BRACKET
(from the 109848 Return Kit)
BLACK 9/16" LARGE HEAD SCREW
(6 used from the 109848 Return Kit for
the BRACKET from the Return Kit)
www.sauder.com/services
Return Kit on the LEFT
BLACK 1-7/8" FLAT HEAD SCREW
F
E2
109872
X
(4 used for the BOTTOM)
H
R
A
R
B
Page 27