Sauder 109872 Manual De Instrucciones página 8

Step 4
Fasten the OUTER END (A) to the SHORT MOLDING (K).
å
Tighten two TWIST-LOCK® FASTENERS.
Page 8
A
i t h
e w
®
f a c C K
S u r
- L O
I S T
E R S
T W
T E N
F A S
K
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the hole of the
adjoining part.
NOTE: The dowel end of the FASTENER must remain fully
inserted in the hole of the adjoining part while locking
the FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver as tight
as possible.
109872
®
FASTENER
Dowel end
www.sauder.com/services