Trouble Shooting; Fault Correction - FLORABEST TLH 2500 A1 Traducción Del Manual De Instrucciones Original

GB MT
Noise and vibration values were deter-
mined according to the standards and
stipulations mentioned in the declaration
of conformity.
Technical and optical changes can be car-
ried out in the course of further develop-

Trouble shooting

Problem
Motor will not start
Garden waste is
not drawn in
Shredding mate-
rial comes out in
chains
50
All manuals and user guides at all-guides.com
Possible cause
Collector box incorrectly at-
tached
Overload protection
No mains power supply
Safety switch is not prop-
erly in place on the collec-
tor box
Cylinder running in reverse
Shredding material is too
soft
cylinder is jammed
Pressure plate is incorrectly
adjusted
ment without notice. All dimensions, refer-
ences and information of this instruction
manual are therefore without guarantee.
Legal claims, which are made on the ba-
sis of the instruction manual, cannot thus
be considered as valid.

Fault correction

Push the collector box home to
its correct position, and place the
safety switch on the box to the ON
position.
To switch back on, start by tur-
ning the operating mode selection
switch ( 9) to the "OFF" position.
A
Press the reset switch (
Switch the device back on.
Check the socket, cable, lead and
plug for damage, and if necessary,
have any damage repaired by
qualified repair personnel.
Move the safety switch into the ON
position (see section on emptying
the collector box)
Change rotational direction using
the switch
Insert wood or shred dried branch-
es
Free up the jam
(See section on working methods)
Readjust the pressure plate (See
section on working methods)
7).
A