Omron M7 Intelli IT Manual De Instrucciones página 33

HEM-7322T-E_D_M.fm Page 31 Friday, July 27, 2018 12:03 PM
4. Error Messages and Troubleshooting
Problem
Nothing happens when you press
the buttons.
Connection failure. /
Data cannot be sent.
Other problems.
Cause
Replace 4 batteries with new ones.
The batteries are depleted.
Refer to section 2.1.
Insert the batteries with the correct
The batteries have been inserted
(+/-) polarity.
incorrectly.
Refer to section 2.1.
The blood pressure monitor might not be properly placed within the
transmission range of the smartphone and is too far from the
smartphone. If there are no causes of data transmission interference
found near the blood pressure monitor, move the blood pressure
monitor within 5 m of the smartphone and try again.
The Bluetooth ® feature of the smartphone is turned off. Turn on the
Bluetooth ® feature of the smartphone and your monitor, and try sending
the data again.
®
The Bluetooth feature of the blood pressure monitor is turned off.
Refer to "To turn "ON" the Bluetooth ® " in section 3.5
The blood pressure monitor did not pair successfully to the smartphone.
Try to pair the devices again.
Refer to section 2.2.
The blood pressure monitor is not ready. Refer to "Note" in "To Transfer
the Data" in section 3.3 and try sending the data again.
The application on the smartphone is not ready. Check the application
then try sending the data again.
Refer to section 2.2.
If the "Err" symbol still lights after checking the application, contact your
OMRON retail outlet or distributor.
• Press the [START/STOP] button and repeat measurement.
• Replace the batteries with new ones.
If the problem continues, contact your OMRON retail outlet or distributor.
Solution
EN
31