Water Drainage; Water Inlet - Zanussi ZWG1100 P Manual De Instrucciones

Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets, rugs etc.
Check that the machine does not touch the
wall or cupboard units.
Carefully level by
screwing the
adjustable feet
in or out.
Never place cardboard, wood or similar
materials under the machine to compensate
for any unevenness in the floor.

Water inlet

Connect the water inlet hose to a tap with
3/4" BSP thread.
Use the hose supplied with the washing
machine. DO NOT USE OLD HOSES.
The other end of the inlet hose which
connects to the machine can be turned in
any direction.
Simply loosen the fitting, rotate the hose and
retighten the fitting, making sure there are no
water leaks.
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the
tap, you will have to purchase a new, longer
hose specially designed for this type of use.

Water drainage

The end of the drain hose can be positioned in
three ways:
Hooked over the edge of a sink using the
plastic hose guide supplied with the
machine.
In this case, make
sure the end cannot
come unhooked when
the machine is
emptying.
This could be done by tying it to the tap with a
piece of string or attaching it to the wall.
In a sink drain pipe branch.
must be above the trap so that the bend is
at least 60 cm above the ground.
Directly into a drain pipe at a height
less than 60 cm and not more than 90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the drain
pipe must be larger than the outside diameter of
the drain hose.
The drain hose must not be kinked. Run it along
the floor; only the part near the drainage point
must be raised.
For the correct functioning of the machine
the drain hose must remain hooked on the
proper support piece situated on the top
part of back side of the appliance.
This branch
of not
7