Water Drainage; Water Inlet - Zanussi ZWI 71000 WA Manual De Instrucciones

Ocultar thumbs Ver también para ZWI 71000 WA:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

POSITIONNING
Install the machine on a flat hard floor. Make
sure that air circulation around the appliance is
not impeded by carpets, rugs etc.
Check that the machine does not touch the wall
or other kitchen units.
If necessary, check the setting with a spirit level.
Any necessary adjustment can be made with a
spanner.
Never place cardboard, wood or
similar materials under the appliance
to compensate for any unevenness in
the floor.

WATER INLET

The inlet hose is supplied with the appliance
and can been found inside the appliance drum.
Do not use the hose from your previous
appliance to connect to the water supply.
This appliance must be connected toa
cold water supply.
18
Fill the smaller upper
hole and the two large
ones with the plastic
plug caps supplied in
the bag with the User
Manual.
Level the appliance by
raising or lowering the
feet.
The feet may be tight
to adjust as they
incorporate a self
locking nut, but the
appliance MUST be
level and stable.
After having levelled
the appliance, tighten
the lock nuts.
Accurate levelling
prevents vibration,
noise and
displacement of the
appliance during
operation.
45˚
35˚
Set the hose correctly by loosening the ring nut.
After positioning the inlet hose, be sure to
tighten the ring nut again to prevent leaks.
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the tap,
you will have to purchase a new, longer hose
specially designed for this type of use.

WATER DRAINAGE

The end of the drain hose can be positioned in
three ways:
Hooked over the edge of a sink using the
plastic hose guide supplied with the
machine.
In this case, make sure the end cannot come
unhooked when the appliance is emptying. This
Connect the hose
with the angled
connection to the
machine. Do not place
the inlet hose
downwards.
Angle the hose to the
left or right depending
on the position of your
water tap.
Connect the hose to a
tap with a 3/4"thread.
Always use the hose
supplied with the
appliance.

Publicidad

Tabla de contenido
loading

Tabla de contenido