Indoor Uint Wiring - Airwell FDMX-050N-09M25 / YDAX-050H-09M25 Manual De Instrucciones

d. Using a wire crimper, crimp u-lugs on
the ends.
NOTE: When connecting the wires, strictly
follow the wiring diagram found inside the
electrical box cover.
2. Remove the electric cover of the outdoor
unit. If there is no cover on the outdoor unit,
take o the bolts from the maintenance
boardand remove the protection board.
3. Connect the u-lugs to the terminals
Match the wire colors/labels with the labels
on the terminal block. Firmly screw the u-lug
of each wire to its corresponding terminal.
4. Clamp down the cable with the cable clamp.
5. Insulate unused wires with electrical tape.
Keep them away from any electrical or metal
parts.
6. Reinstall the cover of the electric control
box.
Indoor Unit Wiring
1. Prepare the cable for connection
a. Using wire strippers, strip the rubber
jacket from both ends of the signal cable
to reveal about 15cm (5.9") of the wire.
b. Strip the insulation from the ends of the
wires.
c. Using a wire crimper, crimp the u-lugs to
the ends of the wires.
2. Open the front panel of the indoor unit.
Using a screwdriver,remove the cover of the
electric control box on your indoor unit.
3. Thread the power cable and the signal cable
through the wire outlet.
Page 34
 
4. Connect the u-lugs to the terminals.
Match the wire colors/labels with the labels
on the terminal block. Firmly screw the u-lug
of each wire to its corresponding terminal.
Refer to the Serial Number and Wiring
Diagram located on the cover of the electric
control box.
wire outlet
control box
Cover
Wiring diagram
Connective wiring diagram
Screw
Magnetic ring
accessories)
CAUTION
While connecting the wires, please strictly
•
follow the wiring diagram.
The refrigerant circuit can become very hot.
•
Keep the interconnection cable away from the
copper tube.
5. Clamp down the cable with the cable clamp.
The cable must not be loose or pull on the
u-lugs.
6. Reattach the electric box cover.
(if supplied and packed with the
1 2 3
Pass the belt through
the hole of the Magnetic
ring to fix it on the cable