Operation; To Start The Product; To Fill Fuel - Husqvarna TS 142K Manual De Usuario

3. Put the freewheel control in the "Transmission
disengaged" position, refer to
storage and disposal on page 35 .
4. Push the product forward off the skid.
5. Remove the strap that holds the deflector protection
up against the product.
To do a check after the assembly
• Make sure that all assembly instructions are
completed.
• Make sure that no remaining parts are in the
package.
• Make sure that the battery is prepared and charged
correctly.
• Make sure that the bolts for the seat are tightened
and that the seat is adjusted correctly.
• Make sure that the tires are correctly inflated.
• For best cutting results, make sure that the cutting
deck is balanced side to side and front to rear. Make
sure that the tires are correctly inflated for a
balanced cutting deck.
• Examine the cutting deck and the drive belts. Make
sure that the drive belts are installed correctly
around the pulleys and inner part of all belt keepers.
Introduction
WARNING:
safety chapter before you use the product.

To fill fuel

WARNING:
flammable. Be careful and refuel outdoors.
Fuel safety on page 9 .
Refer to
CAUTION:
type. Incorrect fuel type causes damage to
the product.
• Use gasoline of the correct type. Refer to
data on page 37 . For more information about the
fuel, refer to the engine manual supplied by the
engine manufacturer.
• Do a check of the fuel level before each use and
refuel if necessary.
• Do not fully fill the fuel tank. Keep a space of a
minimum 1 in.
12
Transportation,

Operation

Read and understand the
Gasoline is very
Always use correct fuel
Technical
• Examine the electrical wires. Make sure that all wires
and connections are safe.
• Make sure that the freewheel control is in the
"Transmission engaged" position. Refer to
Transportation on page 35 .
• Make sure that the engine oil is at the correct level.
• Make sure that the tank is filled with the correct type
of fuel.
• Make sure that you know the location and function of
all controls.
• Make sure that the brake system is in safe to
operate condition.
• Make sure that the Operator Presence Control
(OPC) and the Reverse Operation System (ROS)
operate correctly. Refer to
operator presence control (OPC) on page 7 and To
do a check of the reverse operation system (ROS)
on page 8 .
• Remove the air from the transmission before first
To remove the air from the
use. Refer to
transmission on page 30 .

To start the product

To do before you start the product
WARNING:
product, carefully read and understand the
safety instructions and the operation
instructions.
1. Do a check of the engine oil level. Refer to
check of the engine oil level on page 28 .
2. Fill the fuel tank with fuel. Refer to
page 12 .
3. Disengage the freewheel mode. Refer to
product in freewheel mode on page 17 .
4. Sit in the seat in operation position.
5. Engage the parking brake. Refer to
disengage the parking brake on page 15 .
6. Make sure that the cutting deck is disengaged. Refer
To engage and disengage the cutting deck on
to
page 16 .
To do a check of the
Before you operate the
To do a
To fill fuel on
To put the
To engage and
1720 - 002 - 21.10.2021