To Engage And Disengage The Parking Brake; To Stop The Product - Husqvarna TS 142K Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

To engage and disengage the parking
brake
1. To engage the parking brake, push down the brake
pedal (A) fully to the lowest position.
A
2. With the brake pedal pushed down, pull up the
parking brake lever (B).
3. Release the brake pedal.
4. Release the parking brake lever.
Note:
Make sure that the parking brake holds the
product safely.
5. To release the parking brake, push down the brake
pedal.

To stop the product

WARNING:
engage the parking brake and remove the
ignition key before you go away from the
product.
CAUTION:
warm engine can cause burn damage to the
grass. To prevent burn damage , to the
grass, always stop the engine when you
stop the product on grass areas.
1. Push down on the brake pedal (A) fully until the
product stops fully.
2. Disengage the cutting deck. Refer to
disengage the cutting deck on page 16 .
1720 - 002 - 21.10.2021
B
Always stop the product,
The exhaust gas from the
A
To engage and
3. Put the throttle control in the slow position and let the
engine operate at idle speed for some minutes.
4. Put the cutting deck in the transport position. Refer
To set the cutting deck in transport position or
to
mow position on page 14 .
5. Turn the ignition key to the "STOP" position and
remove the ignition key from the ignition.
To use the throttle control
The throttle control adjusts the engine speed and the
speed of the blades in the cutting deck.
A
Put the throttle control in the fast position (A) to
operate the engine at full speed. Always have the
throttle control in the fast position when you cut
grass.
Put the throttle control in the slow position (B) to
operate the engine at idle speed.
To use the cruise control
Only use the cruise control for forward travel on smooth,
straight surfaces. The cruise control will disengage
automatically if the conditions for cruise control become
unsatisfactory.
B
15

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido