Cutting Deck; To Adjust The Parallelism Of The Cutting Deck - Husqvarna TS 142K Manual De Usuario

Cutting deck

To remove and install the cutting deck
Note:
If an accessory other than the cutting deck is to
be used, the front link and the rear lift links must be
removed from the product. Also, the clutch cable spring
must be put into the cable guide on the front edge of the
lower dash.
1. Disengage the cutting deck. Refer to
disengage the cutting deck on page 16 .
2. Stop the product. Refer to
page 15 .
3. Lower the cutting deck to the lowest position.
4. Remove the drive belt from the clutch pulley (A).
B
H
C
J
D
I
J
5. Remove the clutch cable (B), push the tab (C) and
move the clutch cable out of the bracket.
6. Carefully remove the clutch cable spring (D) from the
idler arm (E).
7. Disconnect the front link (F) from the cutting deck
and remove the retainer spring and washer.
8. Remove the clips (G) and disconnect the suspension
arms (H) from the chassis pins.
9. Disconnect the rear lift links (I) from the rear cutting
deck brackets (J) on each side of the cutting deck.
10. Remove the cutting deck from the product.
11. Install the cutting deck in the opposite sequence.
Make sure that the discharge side is on the right side
of the product.
Note:
The suspension arms must be in forward
position before you move the cutting deck below the
product.
1720 - 002 - 21.10.2021
To engage and
To stop the product on
G
A
F
G
E
H

To adjust the parallelism of the cutting deck

To do a visual side to side adjustment of the cutting
deck
If the cutting height is not the same on the right and left
side of the product, the cutting height can be adjusted.
Adjust the cutting height on the side of cutting deck that
has the lower cutting height.
1. Make sure that the tires are fully inflated.
2. Park the product on a level surface.
3. Go to the side of cutting deck that has the lower
cutting height.
Note:
adjustment.
4. Adjust the cutting height with a 3/4" wrench.
G
Note:
the cutting deck height 3/16" (4.7 mm).
a) Turn the lift adjustment nut (A) to the left to lower
the cutting deck.
b) Turn the lift adjustment nut (A) to the right to lift
the cutting deck.
5. Cut some grass and examine the results. Adjust if it
is necessary.
To do a precision side to side adjustment of the cutting
deck
1. Make sure that the tires are fully inflated.
2. Park the product on a level surface.
3. Put the cutting deck in the transport position. Refer
To set the cutting deck in transport position or
to
mow position on page 14 .
4. Turn the outer blade tips to align with the cutting
deck side to side.
Some models only have left side
A
Each full turn of lift adjustment nut changes
WARNING:
The blades on the
cutting deck are sharp and can cause
injury. Use protective gloves.
25