To Set The Cutting Height; To Remove The Jumper Cables; To Set The Cutting Deck In Transport Position Or Mow Position - Husqvarna TS 142K Manual De Usuario

4. Remove the BLACK cable from the chassis when
the weak battery is fully charged.
5. Remove the BLACK cable from the fully charged
battery.
6. Remove the RED cable from the two batteries.
To use the choke control
Note:
Use the choke control to start a cold engine. Do
not use the choke control to start a warm engine.
A
1. Pull the choke control (A) out to engage the choke.
2. Push the choke control (A) slowly to disengage the
choke.

To remove the jumper cables

Note:
Remove the jumper cables in the opposite
sequence to how you connect them.
1. Remove the BLACK cable from the chassis.
2. Remove the BLACK cable from the fully charged
battery.
3. Remove the RED cable from the 2 batteries.
To set the cutting deck in transport
position or mow position
The cutting deck must be in transport position during
transportation.
• To set the product in transport position, pull the
cutting height lever in the direction of the seat and
put it in the highest cutting height position.
• To set the product in mow position, set the correct
cutting height. Refer to
page 14 .
14
To set the cutting height on

To set the cutting height

• Pull the lift lever in the direction of the seat and put it
in 1 of the notches for the correct cutting height.
To move forward and rearward
The direction and speed of movement is controlled by
the forward and reverse drive pedals.
1. Start the engine.
2. Disengage the parking brake. Refer to
and disengage the parking brake on page 15 .
3. To start movement, slowly push down on the forward
drive pedal (A) or the reverse drive pedal (B).
Note:
The forward and reverse drive pedals go
back to neutral position when they are not pushed
down.
4. Push down more on the forward drive pedal or the
reverse drive pedal to increase the speed.
To engage
A
B
1720 - 002 - 21.10.2021