To Do A Check Of The Engine Oil Level; To Replace The Engine Oil - Husqvarna TS 142K Manual De Usuario

most terrain conditions. The anti-scalp rollers are
adjusted correctly when they are slightly off the ground
when the cutting deck is at the necessary cutting height.
1. Park the product on a level surface and stop the
engine.
2. Adjust the product to the necessary cutting height.
To set the cutting height on page 14 .
Refer to
3. Remove the nut, the bolt, the washer, and the anti-
scalp roller.
3/4"
4. Install the anti-scalp roller, the bolt, the washer, and
the nut in the correct position.
5. Adjust all anti-scalp rollers and install them in the
same procedure.
Engine
To lubricate the engine
Only use high quality detergent oil rated with API service
classification SJ-SN. The oil's SAE viscosity grade
refers to the correct temperature for operation.
5W-30
-20 0 30
F
C -30 -20 -10
Note:
Multi-viscosity oils (5W30, 10W30, and so on)
help the engine start easily in cold weather but causes
increased oil use when used in temperatures above
32°F/0°C. Do a check of your engine oil level frequently
to prevent possible engine damage caused by low oil
level.
• Change the oil after intervals of 50 hours of
operation. If the product is not used for 50 hours in a
year, change the oil at a minimum of 1 time a year.
• Do a check of the crankcase oil level before you start
the engine and after each eight (8) hours of
operation.
• Tighten the oil fill cap/dipstick each time you do a
check of the oil level.
28
9/16"
SAE 30
32 40 60 80
0 10 20 30

To do a check of the engine oil level

The engine in the product is filled with engine oil for
ambient temperatures of more than 32° F (0° C). For
operation in ambient temperatures of less than 32° F (0°
C), use the correct engine oil to make the product easier
to start. Refer to
1. Park the product in level ground.
2. Remove the oil fill cap and dipstick and clean it with
a cloth.
3. Put the dipstick into the oil fill tube. Do not turn the
oil fill cap onto the oil fill tube.
4. Remove the dipstick. Use the gauge on the dipstick
to examine the engine oil level. If necessary, fill
engine oil until the mark "FULL" on the dipstick is
reached. Do not fill too much engine oil.
5. Put the dipstick into the oil fill tube. Make sure that
the oil fill cap is fully tightened.
Note:
To replace the engine oil, Refer to
the engine oil on page 28 .

To replace the engine oil

If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and faster to drain.
WARNING:
for more than 1–2 minutes before you drain
the engine oil. The engine oil becomes very
hot and can cause burn injuries. Let the
engine become cool before you drain the
engine oil.
WARNING:
you spill engine oil on your body, clean with
soap and water.
100
40
1. Put the product on a level surface and stop the
product. Refer to
2. Remove all dirt around the oil tank cap.
3. Remove the oil tank cap and dipstick.
. .
Do not operate the engine
Use protective gloves. If
To stop the product on page 15 .
1720 - 002 - 21.10.2021
To replace