Husqvarna TS 142K Manual De Usuario página 16

1. Push the forward drive pedal (B) down. Keep the
forward drive pedal in a position that gives the
correct speed for the terrain.
A
2. Pull the cruise control lever (A) up and hold it while
you release the forward drive pedal.
3. Release the cruise control lever to engage the cruise
control.
4. Push the brake pedal or tap on the forward drive
pedal to disengage the cruise control.
To use the headlight
• Push the power switch to position (A) to make the
headlight come on.
B
• Push the power switch to position (B) to make the
headlight go off.
To use the reverse operation system
(ROS)
Note:
If you try to go rearward with the product when
the cutting deck is engaged, the engine stops
immediately. Engage the ROS to go rearward with the
product when the cutting deck is engaged.
WARNING:
operate the product rearward, look down
and behind the product for the safety of
others.
16
B
A
Before and while you
1. Turn the ignition key counterclockwise to the ROS
"ON" position (A) to engage the ROS.
A
2. Slowly push down the reverse drive pedal to start
movement.
3. Turn the ignition key clockwise to the engine "ON"
position (B) to disengage the ROS.
To engage and disengage the cutting
deck
WARNING:
deck without a deflector or grass catcher
installed to the grass discharge.
The product has an operator presence control (OPC).
When you go away from the seat with the engine on and
the cutting deck engaged, the engine stops.
Stay fully and in the center of the seat to make sure that
the engine operates correctly and does not stop on
rough terrain or hills.
1. Set the correct cutting height. Refer to
cutting height on page 14 .
2. Move the attachment clutch control.
a) Move the attachment clutch control forward to
engage the cutting deck.
b) Move the attachment clutch control rearward to
disengage the cutting deck.
B
Do not operate the cutting
To set the
1720 - 002 - 21.10.2021