•
Examine the cooling fan to make sure the fan blades
are clean and not damaged.
To examine the transaxle pump fluid
•
Make sure that the transaxle pump fluid does not
leak.
•
Speak to the nearest approved service center or
department if the transaxle pump fluid leaks.
To adjust the front wheel toe-in and camber
The front wheel toe-in and camber is correctly set at the
factory. The front wheel toe-in and camber are not
adjustable.
•
Speak to an approved service center if the factory-
set front wheel toe-in or camber is damaged.
To replace the fuse
This product has an automotive-type fuse. The fuse
holder is located behind the dashboard.
1. Hold the fuse holder and pull the blown fuse out.
2. Put a new fuse in the fuse holder.
To remove and install the engine cover and
the grill assembly
1. Lift the engine cover.
2. Disconnect the headlight wire connector (A).
3. Stay in front of the tractor. Hold the engine cover on
its sides. Tilt the engine cover in the direction of the
engine and lift it to remove it from the product.
4. Install in the opposite sequence.
To replace the drive belt
1. Park the product on a level surface and engage the
parking brake. Refer to
rearward on page 14 .
2. Remove the cutting deck. Refer to
install the cutting deck on page 25 .
1720 - 002 - 21.10.2021
A
To move forward and
To remove and
3. Remove the drive belt from the pulley (A) and the
clutch pulley (B).
E
F
A
B
D
4. Remove the drive belt from the belt tension pulley
(C).
5. Pull the drive belt rearward and remove it from the
transmission input pulley (D) and above the cooling
fan blades.
6. Remove the drive belt from the engine pulley (E) on
the engine shaft.
7. Move the drive belt rearward and above the steering
plate (F) to remove the drive belt from the product.
8. Install a new drive belt in the opposite sequence.
Make sure that you install the drive belt on top of the
steering support plate (F) and the clutch/brake pedal
shaft (G).
Battery
To clean the battery and the terminals
Corrosion and dirt on the battery and terminals can
cause the battery to drain power.
1. Remove the terminal guard.
2. Disconnect the BLACK battery cable.
3. Disconnect the RED battery cable and remove the
battery from the product.
4. Spray the battery with water and let dry.
5. Clean the terminals and battery cable ends with a
wire brush.
6. Lubricate the terminals with grease or equivalent.
G
C
23