Function Introduction For Combination Buttons; Child Lock Function - Daitsu DSF-9UIEE Manual Del Usuario

Introduction for buttons on remote controller Introduction for buttons on remote controller
● When selecting "
displays outdoor ambient temperature.
Note:
● Outdoor temperature display is not available for some models. At that time,
indoor unit receives "
● It's defaulted to display set temperature when turning on the unit.There is no
display in the remote controller.
● Only for the models whose indoor unit has dual-8 display.
● When selecting displaying of indoor or outdoor ambient temperature, indoor
temperature indicator displays corresponding temperature and automatically turn
to display set temperature after three or five seconds.
13
TURBO button
Under COOL or HEAT mode, press this button to turn to quick COOL or quick
HEAT mode. " " icon is displayed on remote controller. Press this button again to
exit turbo function and " " icon will disappear.
14
SLEEP button
Under COOL, HEAT mode, press this button to start up sleep function. " " icon
is displayed on remote controller. Press this button again to cancel sleep function
and " " icon will disappear.
15
LIGHT button
Press this button to turn off display light on indoor unit. "
controller disappears. Press this button again to turn on display light. "
displayed.

Function introduction for combination buttons

Child lock function

Press "+" and "-" simultaneously to turn on or turn off child lock function. When
child lock function is on, " " icon is displayed on remote controller. If you operate
the remote controller, the " " icon will blink three times without sending signal to
the unit.
Temperature display switchover function
Under OFF status, press "-" and "MODE" buttons simultaneously to switch temper-
ature display between ºC and ºF .
" with remote controller, temperature indicator on indoor unit
" signal, while it displays indoor set temperature.
12
" icon on remote
" icon is