Saber R50SB0412 Armado Del Asador Y Guía Del Producto página 27

Troubleshooting - Integrated Electronic Ignition con't.
Problem (Ignition) Possible Cause
SECTION lll
Sparks are present but Output lead connections
not at all electrodes not connected.
and/or not at full
strength. Arcing to grill away from
burner(s).
Weak battery.
Electrodes are wet.
Electrodes cracked or
broken "sparks at crack."
All manuals and user guides at all-guides.com
Check Procedure
Are output connections on and
tight?
If possible, observe grill in dark
location. Operate ignition
system and look for arcing
between output wires and grill
frame.
All sparks present but weak or
at slow rate.
Has moisture accumulated on
electrode and/or in burner
ports?
Inspect electrodes for cracks.
Prevention/Solution
Remove and reconnect all output connections at
module and electrodes.
If sparks are observed other than from burner(s),
wire insulation may be damaged. Replace wires.
Replace battery with a new alkaline battery.
Use paper towel to remove moisture.
Replace cracked or broken electrodes.
27