Publicidad
Idiomas disponibles
Idiomas disponibles
Automatic off function (operating time limitation)
In terms of the setting level, if no operation occurs each cook-
ing zone switches off after an established maximum time.
Each operation in the cooking zone condition (using the
PLUS (C) and MINUS (B) or dual zone) restarts the maximum
operating time of the zone by resetting it to its initial value.
Protection against unintended switching on
· If the electronic control detects a button being held down
for approx. 10 sec. it will switch off automatically. The con-
trol sends out an audible error signal to warn the user that
the sensors have detected the presence of an object. The
displays indicate error code " E R 0 3 ". If the cooking zone
is in "hot" mode, "H" will be indicated alternately on the
display with the error signal.
· If no cooking zone is activated within 20 seconds after
switching on the touch control, it will return to standby
mode.
· When the control is switched on, the ON/OFF button has
priority over all other button and, therefore, the control can
be switched off at any time, even when several buttons are
pressed at the same time or a button is kept held down.
· In standby mode, no effect will be caused by buttons be-
ing kept held down. However, before the electronic control
can be switched back on, it has to detect that no button is
pressed down.
Sound signal (buzzer)
The following activities are indicated by a buzzer during use:
· Normal button pressing by a short sound.
· Buttons kept pressed down for more than 10 sec. by a
long, intermittent sound.
Maintenance (Fig. 4)
By means of a scraper immediately remove any alluminium
foil bits, food spills, grease splashes, sugar marks and other
high sugarcontent food from the surface in order to avoid
damaging the hob.
Subsequently clean the surface with some towel and appro-
priate product, rinse with water and dry by means of a clean
cloth. Under no circumstance should sponges or abrasive
cloths be used; also avoid using aggressive chemical deter-
gents such as oven sprays and spot removers.
Installer's Instructions
Installation
These Instructions are for the qualified technician, as a
guide to installation, adjustment and maintenance, accord-
ing to the laws and standards in force. These operations
must always be carried out when the appliance has been
disconnected from the electric system.
Positioning (Fig. 5)
1 Front view
2 Front side
The appliance can be fitted into a working area as illustrated
on the figure. Apply the seal supplied over the whole perim-
eter of the working area.
Electrical connection
Prior to carrying out the electrical connection, please ensure
that: the plant charac- teristics are such as to follow what
is indicated on the matrix plate placed at the bottom of the
working area;
- that the plant is fitted with an efficient earth connection,
following the standards and law provisions in force.
- The earth connection is compulsory in terms of the law.
Should there be no cable and/or plug on the equipment, use
suitable absorption material for the working temperature
as well, as indicated on the matrix plate. Under no circum-
stance must the cable reach a temperature above 50°C of
the ambient temperature.
Publicidad
