Power Connections - Hach DR 6000 Manual Del Usuario

Figure 2 Back view
1 On/off switch
2 Socket for power cable
3 Ethernet port
4 USB port type B
5 USB port type A
6 Filter pad cover

Power connections

N O T I C E
Use only a grounded socket for the connection of this device to the power supply.
If you are not sure if the sockets are grounded, have this checked by a qualified
electrician. The power plug serves in addition to the power supply to isolate the
device quickly from the power source where necessary. During the disconnection
from the power source it must be made sure that the correct power plug is pulled
(for example by labeling the sockets). This is recommended for long-term storage
and can prevent potential dangers in the event of a fault. Therefore make sure
that the socket to which the device is connected is easy to reach by each user at
all times.
WA R N I N G
Electrical dangers and fire hazard.
Only use the supplied power cable.
1. Plug the power cable into the back of the instrument
page 151).
2. Insert the plug of the power cable into a grounded mains socket
(100–240 V~ / 50–60 Hz).
3. Switch the power button to "On" to turn on the instrument
view, page 151).
(Back view,
(Back
English 151