Configure A Panel To Operate A Port Or Starboard E-Drive Motor - Vetus ELPS Manual De Instalación

ENGLISH
4 .6 Configure a panel to operate a port or star-
board E-drive motor
Carry out the following actions on EACH panel in the order indi-
cated:
N.B. The panel must be in the OFF position (if the panel is NOT in the
OFF position, first long press the "START/STOP" button to turn the
panel to the OFF position.
1
2
10 seconds
2 Place the panel in configuration mode.
• Press and hold the 'START/STOP' button for 10 seconds.
3
1 x
4
1 x
BLUE
4 Configuring for a port side motor: Move the lever to the left once. The 'START/STOP'
button LED lights up blue.
Configuring for starboard motor: Move the lever to the right once. The 'START/STOP' but-
ton LED lights up red.
For a port and starboard panel, together on a helm station, the
set helm station number must be the same .
12
370401.11
1 Move the lever to the left.
dididididididid ( . . . . . . )
6 seconds
3 Press the 'START/STOP' but-
ton to confirm. Now the pan-
el is in configuration mode.
1 x
RED
n
ote
1
As delivered, the panel is configured for a port side motor .
dididididah ( . . . . − )
Con guration mode
4 seconds
During the first 6 seconds, the buzzer will continuously signal a did-
ididididi ..... (. . . .). Keep pressing the START/STOP button. After 10
seconds the buzzer sounds the signal dididididah (. . . - -).
5
5 Press the 'START/STOP' button once to con-
firm the setting.
Settings are retained when the power supply is switched off!
vetus® Installation manual E-Drive motor control lever ELPS - ELPSR
2
n
ote
1 x
n
ote