When The Auger Stops During Operation - nama Vitality 5800 Manual De Instrucciones

19
When Auger Stops During Operation
*The appliance may stop if ingredients are overloaded or inserted quickly.
*Gradually insert ingredients, since the product squeezes them instead of grinding.
Caution when using operation button
[ON]
In case of reversing during operation, press [REV] button shortly to stop
the appliance, then you press [REV] button for operation.
NOTE
From the feature of the product, even though you stop the operation, it doesn't stop
right away. It rotates slowly then stops. If the rotation stops completely, you may
press the button to any direction you want.
1
[REV]
2
[ON]
NOTE
Even after following the directions above and
still doesn't work, please unplug the power
cord and disassemble chamber set, and clean it.
Then, try it again.
[STOP]
Press [REV] button on the operating
switch for about 3~5 seconds and stop it.
Repeat this 2~3 times.
[REV] is the button to push back the ingredients
upward.
[REV] only works while pressing the button, and
the rotation of the auger stops If you release the
button.
Press [ON] button to operate after
reverse operation is completely stopped.
When using [ON] or [REV] button, make sure
that the auger stops completely.
[REV]