Additional Safety Information; Introduction; Assembly; Assembling The Hose To The Tank - Smith XP100P Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGLISH
• Never pressurize the sprayer with any device
other than the pump supplied by the original
manufacturer. Use of an air compressor or other
non-standard device to pressurize the system could
exceed the safe working pressure of the sprayer.
• Do not lift, carry, or pull the sprayer by the hose,
shut-off, or wand extension. Doing so could
weaken the components and/or connections. Carry
by the handle or harness only, making sure the
connections are properly secured before lifting.
• To reduce the risk of electrical shock, do not put the
sprayer in water or other liquid. Do not place or store
the sprayer where it can fall or be pulled into a tub
or sink.

Additional Safety Information

WARNING: Never modify the sprayer or any part
of it. Damage or personal injury could occur.
SAVE THESE INSTRUCTIONS
FOR FUTURE USE

INTRODUCTION

This is an electric-powered compressed-air style tank
sprayer that is designed to spray liquid chemicals
typically used for pest control.
This Sprayer uses an internal rechargeable Lithium-Ion
Battery to power an electric air compressor Pump.
The PumpZero Electric Pump is designed to provide a
more convenient and more consistent alternative to
standard manual pumps. It operates by pressurizing
the air above the fluid in the Tank, which causes the
fluid to be pushed through the Hose, to the Nozzle,
and sprayed out. Because the PumpZero Electric Pump
operates by pressurizing air in the Tank, it is important
that a good air seal is achieved when the Pump is
tightened into the Tank.
While actively spraying it is normal for the Pump to
turn on and off by itself periodically; it is not expected
to run continuously. The Pump will pressurize the air
inside the Tank, then turn off and let the air pressure
do the work of spraying out the fluid. As the fluid
is sprayed out, the air pressure inside the Tank will
decrease, eventually causing the Pump to turn on
again. Having the Pump turn on and off in this manner
allows for longer Battery life and greater Pump
longevity, compared to a continuously running Pump.
The PumpZero Electric Pump contains an internal
Lithium-Ion Battery. The shipment of Lithium-
Ion Batteries is subject to international shipping
regulations. Accordingly, the Battery must be in a
reduced-charge state for shipping, so the Pump must
be charged prior to initial use. As with all products
containing Lithium-Ion Batteries, consult your local
4
shipping agent for instructions prior to shipping the
Pump.
The PumpZero Electric Pump is equipped with an
auto-off feature that turns the Pump off after 2 hours
of inactivity. This is to prevent the Battery from being
drained if the Pump is left on when the Sprayer is not
in use.

ASSEMBLY

WARNING: RISK OF PERSONAL INJURY AND/OR
PROPERTY DAMAGE DUE TO CHEMICAL EXPOSURE.
After initial assembly, always inspect the sprayer for
damage, and test it with plain water to check for
proper function. Ensure all connections are secure
and leak free, and the hose is free from damage, prior
to using the sprayer with chemicals.
WARNING: Only use attachments recommended or
sold by the manufacturer.
WARNING: For Household Use Only.

Assembling the Hose to the Tank

NOTICE: Do not attempt to heat or alter hose, hose
nut, or barb prior to assembly.
1. Align Hose Barb tabs, push Hose Barb (1) into
Tank until it stops.
1. Slide Hose Nut (2) into place and turn clockwise
to tighten
NOTE: Do not use tools to tighten Hose Nut.
1
2

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

190728

Tabla de contenido