NATURE & DECOUVERTES 42000880 Manual Del Usuario página 28

2.5V 18
2 2
3V +
19
15
2 2
OF FO N
+
2 2
24
3V +
19
15
2 2
OF FO N
1. Basic Circuit
Place the breadboard on a table flat side down. Assemble the parts as illustrated. Put
the 2.5V bulb into the lamp 18 . Put two „AA" batteries into the battery unit
slide switch 15 on. The lamp 18 goes on. Turn the slide switch off, and the lamp goes off.
2. Basic Circuit
Replace the slide switch with the reed relay . Place the magnet near the reed
15 13
relay . The lamp goes on. Remove the magnet and the lamp goes off.
13 18
13
3. Electric Motor
Assemble as illustrated. Make certain the slide switch is OFF. Turn on the slide switch
15
. The motor starts.
15 24
WARNING: moving parts. Do not touch the fan or motor during operation.
4. Magnetically Activated Motor
Replace the slide switch with the reed relay . Place the magnet near the reed
15 13
relay . The motor turns on. Remove the magnet and the motor turns off.
13 24
WARNING: moving parts. Do not touch the fan or motor during operation.
54
2.5V 18
19 . Turn the
3
3 3
3 3
OF F OF FO
5. Lamp and motor in series
+
Assemble as illustrated. Ensure the battery units
24 2 2 the slide switch 15 . Both motor
WARNING: moving parts. Do not touch the fan or motor during operation.
6. Lamp and motor in parallel
3
Assemble as illustrated. Turn on the slide switch
operate. Turn off the slide switch and they both stop.
18
3V +
WARNING: moving parts. Do not touch the fan or motor during operation.
19
15
N
55
19 are in the same direction. Turn on
24 and lamp 18 operate.
. Both the motor and the lamp
15 24