Inserting/Removing The Battery Pack; Checking The Battery Charge Level; Fitting The Belt Clip; Switching On/Off - Parkside PASSP 20-Li A2 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 106

Inserting/removing the battery pack

Attaching the battery pack
Push the rotation direction switch
middle position (lock). Push the battery pack
into the handle until it clicks into place.
Removing the battery pack
Press the release button
battery pack
.

Checking the battery charge level

Press the battery charge level button
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Fitting the belt clip

Loosen the fixing screw
Phillips screwdriver (not supplied).
Hold the corresponding hole of the belt clip
over that of the screw thread.
Tighten the fixing screw
8
GB │ IE
into the
and remove the
to
as follows:
using a standard
3a
.
3a
Switching on/off
Turn on
Press and hold the ON/OFF switch
start up the tool.
The LED work light
ON/OFF switch
This provides illumination of the work area in
poor lighting conditions.
Switching off
Release the ON/OFF switch
the appliance.
Setting/preselecting the rotation
speed/tightening torque
Press the torque selector
required torque in stages. The selected torque is
shown on the torque display
Press the ON/OFF switch
speed and a low tightening torque. Increasing
the pressure increases the speed and the tight-
ening torque.
The tightening torque depends on the selected
speed/torque selection and impact duration.
NOTE
When tightening wheel nuts, however, the
smallest torque setting must be selected to
avoid over-tightening.
The integrated motor brake ensures that the
tool stops quickly.
ATTENTION!
The tightening torque actually attained must
always be checked with a torque wrench!
to
lights up when the
is pressed lightly or fully.
to switch off
to select the
.
lightly for a low
PASSP 20-Li A2

Publicidad

Tabla de contenido
loading

Tabla de contenido