Extremis STICKS Manual Del Usuario página 6

ASSEMBLY STICKS
MAINTENANCE
The rubber and the fibre glass rods do not require
special maintenance. They can simply be kept dustfree
with a slightly damp cloth.
WARNING
During the production process tiny glass fibres may
come loose and remain stuck to the rods. In case
of skin contact they may cause slight irritation. We
consequently recommend that you thoroughly dust or
rinse the rods before inserting them into the bases to
reduce these fibres to a minimum.
Only the rubber bases and the fibre glass rods are
perfectly suited for outdoor use.
If Sticks is exposed to strong winds, it might be
necessary to fix its base to the ground.
Do not allow anyone to use the rods for playing or
jousting. They may cause injuries.
6 sticks
Insert the rods in the holes in the base.
USEFUL ADVICE
You do not have to insert all the rods. If you want more transparency, just
use less rods..
To create a special effect, you can mix differenty coloured rods or create
smooth colour transitions.
FOR THE RUBBER BASE
When you disassemble the Sticks space divider, bundle the rods with the
same side up or down, as the base sometimes leaves marks on the rods.
When re-inserting the rods in the base, make sure they are facing the same
way as they did before the disassembly.
The base in rubberwood has been treated with wood oil.
If so desired, you can repeat this treatment after a while.
If you intend to put the rubber base on a delicate
surface, we recommend using the supplied feet.
Do not touch the fibre glass rods with your bare hands.
Always use a glove to assembly Sticks.
Because of the specific characteristics of the production
process of fibre glass, colours can only be reproduced
approximatively and colour differences may occur. This
is the case for both standard colours and colours upon
request.