Yamaha E40X Manual Del Propietário página 44

UP
UP
DN
DN
EMD20310
Power trim and tilt switch
The power trim and tilt adjusts the motor
angle in relation to the transom. The
power trim and tilt switch is located on
the remote control lever grip. Pushing the
switch UP trims the motor up, then tilts
the motor up. Pressing the switch DN tilts
the motor down and trims the motor
701034*
down.
released, the motor will stop in its current
position.
w
Excessive trim for the operating condi-
tions (either trim up or down) can cause
boat instability and can make steering
the boat more difficult. This increases the
possibility of an accident. If the boat
begins to feel unstable or is hard to steer,
slow down and/or readjust the trim
angle.
EMC87011
Throttle friction adjusting screw
A friction device in the remote control box
provides resistance to movement of the
remote control lever.
This is adjustable for operator preference.
An adjusting screw is located at the front
of the remote control box.
701035
Resistance
Increase
Decrease
w
Do not overtighten the friction adjusting
screw. If there is too much resistance, it
may be difficult to move the lever, which
could result in an accident.
2-10
When the switch
Screw
Turn clockwise
Turn counterclockwise
GB
button is