Use Instructions - Beper 40.610BL Manual De Instrucciones

Máquina eléctrica para cortar el pelo
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Hair clipper Use instructions

USE INSTRUCTIONS

NOTICE
For the first use of the cut clipper, you have to cut a little bit hair.
Before starting hair cut :
– Inspect the clipper, making sure that it is free of oil between the cutting blade teeth and turn the
unit on to distribute the oil and to make sure it is running smoothly;
– Place a towel around the neck and shoulders of the person having the haircut;
– Seat the person so their head is approximately at your eye level. This allows ease of visibility while
cutting and a relaxed control of the unit;
– Before cutting always first comb the hair so it is tangle free and as it is naturally worn;
– Cut the hair in a relaxed and slow manner. Use short stroked only to work gradually over the entire
head ;
– Always take off a little hair at a time, you can always trim off additional hair later;
– As you work, comb the hair frequently back into the style to which you are cutting;
– When cutting with this hair clipper it is better to leave the hair dry, not wet.
USE
Take off the blade protection (7) and insert completely the attachment comb (8), and choose the
right size.
• Attachment Comb #1 leaves 3mm (1/8 inch)hair length.
• Attachment Comb #2 leaves 6mm (1/4 inch)hair length.
• Attachment Comb #3 leaves 9mm (3/8 inch)hair length.
• Attachment Comb #4 leaves 12mm (1/2 inch)hair length
Plug the cord and put the switch on I (5).
Hair must be clean, dry and combed. For the first use of this appliance, you have to start from the hi-
ghest length of hair, and then reduce gradually in order to prevent cutting more hair than requested.
For cutting, hold the clipper comfortable in your hand and hold lightly against the head with the comb
teeth pointing upward. Gradually and slowly lift the clipper through the hair, trimming just a little a
time and often comb hair in order to obtain the requested style
The lever (6) is conveniently located near your thumb (if your' re right-handed) so it can easily be
adjusted while the clipper is in your hand
The lever adds versatility to your clipper by allowing you to gradually change the closeness of your
cut without an attachment comb (8).
When the lever (6) is in the uppermost position, the blades will give you the closest cut and leave the
hair very short. Pushing the lever downward gradually increases the cutting length
In addition, if extremely heavy hair cutting has jammed the blades, it will help you remove hair that
has become wedged between the two blades without removing the blades. Fig.2
12

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

40.610r

Tabla de contenido