Technical Data - Beper 40.610BL Manual De Instrucciones

Hair clipper Use instructions
The blades (1) have been aligned and oiled in factory. To maintain your clipper in peak condition, the
blades should be oiled every few haircuts and could be useful to make a new alignment.
Unscrew and take off screws. Fig.8
To realign the blades, simply match the upper and bottom blades teeth up. Point for point. (End
of top blade teeth should be approximately 1.2mm back from bottom blade. Compare your clipper
blades with the sketch.
Screw firmly the screws. Fig.9

TECHNICAL DATA

Power 10W
Power supply 220-240V ~ 50/60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product
without any notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE),
requires that old household electrical appliances must not be disposed of in the normal
unsorted municipal waste stream. Old appliances must be collected separately in order to
optimize the recovery and recycling of the materials they contain, and reduce the impact on
human health and the environment. The crossed out "wheeled bin" symbol on the product
reminds you of your obligation, that when you dispose of the appliance, it must be separa-
tely collected.
14