How To Listen To The Fm Radio - Midland BTX2 PRO Manual De Instrucciones

3. Now press firmly (3 sec) the "Volume +" or "Volume -" button, the Blue and Red
lights will flash.
4. Enable the Bluetooth device search feature on your GPS
5. After some seconds, "Midland BTX2 PRO" will be displayed on your GPS.
6. Follow the pairing procedure of your GPS. If a pin code is requested you must enter
"0000" (four times zero).
When successfully paired, the Blue light of the unit will be on for one second and then
the unit will exit the setup mode and switch to the working mode (the Blue light will
start flashing). You can now use your Midland BTX2 PRO and the GPS street voice
announcement are always in background. If you pair the GPS to the Volume + button
(because for example the "Volume –" button was already used), you lose the possibility
to pair the phone to the Midland BTX2 PRO unit. You can overcome this limit by pairing
the phone directly to the GPS and then the GPS to the Midland BTX2 PRO unit. All
the phone features are therefore managed by the GPS itself.
Pairing to a PMR446 radio with integrated or external Bluetooth
The PMR446 Radio can be paired to the "Volume +" or "Volume -" button. If paired
on "Volume -" and the "Background" feature is activated, the PMR446 radio is always
in the background even when you talk on the intercom.
Pairing procedure
› Turn off the unit
› Press and hold down the "Middle" button about 7 sec., until the Red light is on per-
manently.
› Now press firmly (3 sec) the "Vol +" or "Vol -" button, the Blue and Red light will
flash.
› Follow now the pairing procedure explained on the manual of the transceiver itself.
C-Radio FM mode
Mode
FM Radio
12
All manuals and user guides at all-guides.com
Forward button
Short press: seek station up
Long press: Scan recorded

How to listen to the FM Radio

The FM Radio receiver is integrated inside the unit. You just need to switch to the "FM
Radio" mode in order to use it. Long press the middle button until you hear "FM radio"
from the voice announcement. Now all the three main buttons are dedicated to the FM
Radio (See Table C).
Press short the Forward or the Backward button to seek the FM Radio station.
When you press long the Forward or the Backward button, you can scan up or down
the 6 recorded stations. A voice announcement will tell you the number of which me-
mory you are entering. To save the station you are listening to, press the Forward and
Backward buttons together for 3 sec. You will hear a beep tone for confirmation.
The station is saved over the last recorded station used.
Thanks to the RDS system, the FM Radio will choose the strongest signal available for
the radio station you like to listen. The RDS system is OFF by default, if needed you can
toggle on/off the RDS pressing together the "Volume +" and "Volume –" buttons for 3
sec when the radio is on. A voice announcement will tell you the RDS status.
How to Disable/Enable the FM Radio
By default the FM radio is on.
Disabling:
› Enter the "Setup" mode: turn off the unit and hold down the "Middle" button about
7 sec., until the Red light is on permanently.
› Press "Middle" and "Volume+" buttons together for 3 seconds. The blue LED will
flash three times.
› Double click on the "Middle" button to exit the "Setup" mode and use the Midland
BTX2 PRO
Middle button
Short press: On/off
Long press: Change mode
Rear button
Short press: seek station up
Long press: Scan recorded
www.midlandeurope.com