Bodypoint SH224 Instrucciones De Instalación Y Para El Usuario página 2

PACKAGE CONTENTS
• Shoulder harness
• Detachable top straps with 3-bar-slide
adjusters (2)
• Flat-Mount end-fittings (4)
™
FITTING
1. Seat user in wheelchair and
establish correct posture with
Pelvic Support Belt (not included).
2. Place shoulder harness on chest
with pads over top of shoulders
and top straps over the back
support. Position straps between
neck and shoulder joint.
3. Center the buckled sternum strap
on the sternum and adjust pad
spacing as needed.
4. Adjust harness position up/down
to distribute pressure evenly across
the ribcage and shoulders.
DIRECT MOUNTING OPTION
Attach Cam Buckle (Art. No. FS032-2;
not included) to the back support
using suitable fasteners. Thread
webbing through buckle. Suitable for
users up to 75kg.
SAFETY CHECK
When properly positioned in wheelchair, have user lean
forward and side-to-side to check fit. Check for:
1. Normal operation of buckles and adjustment straps.
2. Comfort: If rubbing neck, relocate upper straps.
3. Position: If too high or too low adjust lower straps.
4. Interference with other devices: Relocate straps as
necessary to clear seat tilting mechanism, armrests,
accessory pads, or feeding tubes.
For additional guidance on the installation, fitting and use of these products, visit www.bodypoint.com.
0°
INSTALLATION REQUIREMENTS
1. Wheelchair with a solid back support or strap guides set approximately
at shoulder height (adjust up/down for pressure distribution).
2. Mounting screws, Ø5-6mm (3/16 - 1/4"), with a minimum pullout
strength of 90kg/200lbs. Not included in package.
TOP STRAP INSTALLATION
1. Using 3-bar-slide adjusters, assemble detachable top straps to harness and
end-fittings.
2. Adjust each shoulder strap for a comfortable fit, according to the user's
shoulder width and sitting position. Mark for mounting screws to maintain this
position.
3. Attach the detachable top straps to the back support using suitable fasteners.
4. With user properly positioned in chair, tighten the top straps to position the
pads and to properly support the user.

Good fit
Package Contents
0°
Strap Guides
(optional)
Art. No. HW100
WARNING! Do not
place the top strap
buckle on top of the back
support. Under tension,
the strap can slip out of
adjustment, allowing the
user to fall forward.
LOWER STRAP INSTALLATION
1. Wrap lower straps around the back
support between the lowest rib and the
seat without obstructing other devices
on wheelchair.
2. Mount straps to the back support, using
Bodypoint end-fittings and suitable
fasteners.
3. With user properly positioned in chair,
adjust the lower straps to prevent the
sternum strap from riding up.
Too high
en
Too low